AZTools.us

Merge & Join Multiple MP3 Audio Files

Track list + combined waveform with seams Seamless multi-track merge

Adjustments

Load a file to unlock this tool’s controls:

Track list + combined waveform with seams

Runs directly on the web inside your browser. Your original file is never modified or uploaded.

How Merge & Join Multiple MP3 Audio Files Works

This tool joins two or more audio files into one, in the order you choose. You can trim each track, leave a gap of silence between them or crossfade one into the next, and listen to every join before you export a single MP3, M4A or WAV. The files can be different formats and sample rates; all decoding and mixing happens in your browser.

How to merge MP3 files into one

  1. Drop several files at once (.mp3, .wav, .m4a, .ogg, .flac, .aac or .opus). Use “+ Add files” to add more later; new files go to the end of the list.
  2. Reorder the list by dragging the ⋮⋮ handle, or focus it and press ↑ and ↓ (Home and End jump to the first or last place). ✕ removes a track.
  3. To shorten a track, press “Trim” on its row and type the “Start” and “End” times (m:ss.s). “Full track” undoes the trim.
  4. Pick “Gap” and set the silence, or “Crossfade” and set its length.
  5. Press “▶ Play”, or click the combined waveform to listen from any point; click an amber ▼ marker to hear a join from 3 seconds before it. Then set “Volume” and “Quality”, choose the format and export.

Gap or crossfade

“Total” shows the length of the finished file, which already accounts for gaps and overlaps.

Join settings
SettingRange and behaviour
Gap0–10 s in 0.1 s steps, 0 by default (tracks play back to back)
Crossfade0.1–10 s, 2 s by default. Equal-power: the outgoing track falls on a cosine curve while the next rises on a sine, so the level stays even. Each crossfade is limited to half of the shorter of the two tracks; the line under the controls shows the actual length at every join
Volume50–200% for the whole result. When boosted or overlapping audio goes over the limit, a limiter holds the peaks so nothing clips

Mixed formats and sample rates

The result uses the highest sample rate among your tracks; tracks at a lower rate are resampled, and each row shows the change (for example 44.1 kHz → 48 kHz). If any track is stereo the result is stereo, and mono tracks play in both channels. A 5.1 or 7.1 track is mixed down to stereo (centre and surrounds at −3 dB, LFE left out) and its row says so.

Quality defaults to 192 kbps for MP3 and 128 kbps for M4A (AAC). WAV is uncompressed 16-bit. The file is named after the first track with “-merged” added. If a file cannot be decoded by your browser, it is skipped and named in a message; the other tracks stay in the list.

Questions

Is there a limit on how many files I can join?
The tool sets no fixed limit. Every track is decoded into memory, so very many long files can make the browser tab slow or run out of memory. Joining in batches works if that happens.
Why is the crossfade shorter than the value I set?
A crossfade can be at most half of the shorter track at that join, so a short clip limits it. The seam line under the controls shows the length used at each join.
Are my files uploaded?
No. Decoding, mixing and encoding run in your browser tab, and only the file you export is saved.